Universal remote control with programming zone for inext TV5, TV5 Ultra, TV4, 4K Ultra, TV2e, TV3, 4K2.
Programming buttons for TV control
1. Entering the remote programming mode is done by pressing the «POWER» button in the «TV» section. Hold down the «POWER» button (approx 5 sec) until the indicator stops blinking and start burn continuously.
2. Select one of those buttons in the «TV» section on the inext remote control to which you want to record a command, press it once and release, the indicator will flash, now the remote control is ready to receive the IR signal for recording.
3. Pointing at each other the IR diodes of the two remotes (from the TV and from the inext) at a distance of about 1-2 cm, press the desired button on the TV remote control, the function of which you want to transfer. If the command has been accepted, the indicator will blink three times and start to burn continuously, which means that the command has been recorded.
4. Repeat steps 2-3 for all buttons you wish to program.
5. If you have written down all the commands and want to exit the programming mode, press the button «OK» in the center of the remote control.